Re: Using Kenwood AT-200 ATU For QRP Ops [ Follow Ups | Post Followup | Return to QRP Forum ]

Posted by:  Stuart K5KVH Posted On:  09/05/01 Subject:  Re: Using Kenwood AT-200 ATU For QRP Ops Message Posted:     In Reply to: Using Kenwood AT-200 ATU For QRP Ops posted by Steve N5WBI on 08/21/01 I would say for any tuner use, with it inline, peak it on received noise from the receiver. That will get you close and then tune the SWR Power meter for max sensitivity in Forward, then in reverse read SWR as you adjust each transmatch control. Key intermittently, and adjust, if SWR is high. Keep this iterative process up until you have minimum SWR and max power

Follow Ups: Re: Using Kenwood AT-200 ATU For QRP Ops   Steve N5WBI   Posted on 09/05/01 (4) Re: Using Kenwood AT-200 ATU For QRP Ops   Shannon Grant   Posted on 10/05/04 (0) Re: Using Kenwood AT-200 ATU For QRP Ops   Tilly Hogan   Posted on 09/28/04 (0) Re: Using Kenwood AT-200 ATU For QRP Ops   Jessica Baird   Posted on 09/28/04 (0) Re: Using Kenwood AT-200 ATU For QRP Ops   Dot King   Posted on 08/27/04 (0)

Post a Followup
Name/Call:
E-Mail:
Subject:
Message to Post:
	Use Fixed Width Font (Useful for lining up columns of data in log sheets)
Link URL:	(This can be a link to a web page or anything else.)
Link Name:	(This is an optional description or title for the URL above.)
Picture:	(This must be the full address of a .JPG or .GIF)
	Check this box to receive an e-mail when someone replies to your message

[ Posting Rules | Follow Ups | Return to QRP Forum ]